Problems we see in shared buildings
- Suite shut-off valves seized open, so no one can isolate a leak.
- Water marks on the ceiling of the unit below a bathroom or laundry.
- Kitchen stacks that back up on lower floors when upper suites drain.
- Pressure that drops on top floors during the morning rush.
How a multi-unit job is planned
- The manager or superintendent confirms access to suites and mechanical rooms.
- Residents get notice of any riser shut-off and its expected length.
- We isolate the smallest section that makes the repair safe.
- Lines are refilled slowly, air is bled from fixtures and each affected suite is checked.
The visit, in order
- 1
Find and test the main shut-off before opening anything.
- 2
Locate the fault at the fixture, the wall or the line.
- 3
Repair with matching parts and proper fittings.
- 4
Run water, test every joint and clean the work area.
Who pays for what
An Ontario condo's declaration normally spells out where unit piping stops and common-element piping starts. We do not decide that, but we document where the failure was found, with photos, so the board and owner have what they need.
Stacked towns and small walk-ups
Cornell and Markham Centre stacked townhomes often share drains between upper and lower units. A blockage from one household can appear in the other, so we camera the shared branch before cabling blindly.
Straight from the phone log
Is a full-building shutdown needed to change one riser valve?
It depends on the valve layout. Some risers have sectional valves; others need a building shut-down. We check before booking so residents get proper notice.
Will you deal with our board and management office?
Gladly. Bookings go through the office, and photos plus a short write-up follow every visit.
Ready to get it fixed?
One call, a clear explanation, and work finished tidily before we leave.