Skip to content
Call a plumber(365) 414-5810
Snow-dusted house among trees and power lines
Snow-dusted house among trees and power lines

East Markham

Plumbing in Raymerville

Raymerville is a settled 1970s neighbourhood east of McCowan. Its houses are now about fifty years old, and that is when copper, cast iron and original valves start asking for attention.

  • Plumbers who know Raymerville housing stock
  • Drains, leaks, heaters and sump pumps handled
  • Clear explanation before any work starts
  • Phone answered by a plumber
Phone answered by a plumber(365) 414-5810
  • Licensed trade work
  • Homes & businesses
  • Same-day visits when possible
  • Markham & York Region

Homes and streets in Raymerville

Raymerville sits around McCowan Road and Highway 7, with Raymerville Drive running through quiet crescents of detached houses and back-splits. Most homes went up in the 1970s on established lots with mature trees.

Original copper supply, cast iron drain stacks and early ABS branch drains are typical. Plenty of owners have redone kitchens and baths while the original pipe behind the drywall stayed put.

Plumbing problems we see there

  • Cast iron stacks scaling inside and slowing upper-floor drains.
  • Main shut-offs that turn but never fully close.
  • Pinhole leaks in basement ceiling copper.
  • Roots in laterals under mature trees.
  • Tub drains with worn overflow gaskets.
If upstairs tubs and basins drain slowly but the basement is fine, the stack between floors is a likely suspect.

Seasonal concerns

Late summer root growth and fall leaf drop can bring lateral trouble. Winter tests exterior wall pipes and hose bibs in older back-splits.

Services most requested

We are most often asked for main valve replacement, drain cleaning, leak detection and camera inspections. Nearby Markham Village has older stock still.

Back-splits and hidden branches

In a back-split, the kitchen sits half a level above the family room and its drain often runs through a short, tight ceiling cavity before reaching the stack. That flat section is a classic grease trap. Clearing it properly means working from the kitchen and checking flow at the lower level. We also find old galvanized nipples hidden at water heater connections in some Raymerville basements, worth swapping before they rust through.

Markham note: village-core houses tend to hide cast iron and galvanized behind plaster, while Cornell and Box Grove builds run PEX to a manifold. We ask the year your house was built so the right fittings ride along on the truck.

Straight from the phone log

Is it worth replacing a fifty-year-old main valve?

Yes, if it does not close fully. Swapping in a lever-handled ball valve is quick and earns its keep in the first emergency.

Can a cast iron stack be partly replaced?

Often. Damaged sections can be cut out and joined to new pipe with proper couplings.

Ready to get it fixed?

One call, a clear explanation, and work finished tidily before we leave.

Call (365) 414-5810